How do I configure recording to the Micro SD card on my DCS-942L?
To setup recording to the Micro SD Card, configuration must be performed within the Web Interface of the DCS-942L. This can be done using the Cameras IP address or using the mydlink web portal.
Option 1: mydink Portal
Step 1: Go to www.mydlink.com and log into your account
Step 2: Select your DCS-942L and click on the Settings Tab
Step 3: Click on Advanced Settings
Option 2: Using the Camera IP Address
Note: If you already know the IP address of your DCS-942L, skip to the next section "Configuring your DCS-942L for recording"
Step 1: Launch the Install Wizard for the DCS-942L
Step 2: Click Next until the wizard searches for your camera
Step 3: When found, record the IP address of the camera you want to configure for recording.
Configuring your DCS-942L for recording
Step 1: Open your internet browser and type the IP address of your DCS-942L into the address bar
Step 2: When prompted, enter your username and password for the camera (The default username is admin and there is no password)
Step 3: Click on the Setup Tab and then click on SD Management on the left side
Note: You must format the installed SD card to allow the DCS-942L to read it. Formatting will cause all data on the SD card to be erased.
Step 4: