How to: Setup Motion Detection Videoclip to NAS for DCS-5222LB1
How to: Setup Motion Detection Videoclip to NAS for DCS-5222LB1
Step 1: Connect the power of the camera and connect LAN cable from the camera to your router.
Step 2: Run the CD that come with the camera on your computer.
Step 3: Click on next
Step 4: Put a tick in the box beside ‘I accept these terms and conditions.’ Click on Next
Step 5: Click on Next
Step 6: Click on Next
Step 7: Click on Next
Step 8: Click on Next
Step 9: Click on Yes.
Step 10: Copy down the IP address of the DCS-5222L show in the list.
Step 11: Open Internet Explorer and enter the IP address of the camera that you had copy down on the URL bar.
Step 12: Enter the camera user name and password that had set during setting up of the camera. Click on OK.
Step 13: Click on Setup > Motion Detection.
Step 14: Under the Live Video section, configure the following;
a) Tick Enable Video Motion
b) Tick Enable PIR
c) Select the area you want motion to be detected.
d) Click on Save Settings
Step 15: Click on Setup > Event setup
Step 16: Under Server, click on Add.
Step 17: Under Server Type, Give a Server Name.
Step 18: Select Network Storage
a) Enter the network path which you want the files to save to Network Storage Location.
b) Enter the user name and password which you assign to the folder to User name.
c) Click on Save Settings.
Step 19: Under Media, click on Add.
Step 20: Under Media Type,
Give a Media Name.
Step 21: Select Video Clip.
a) Select Profile for Source
b) Put 3 for pre-event recording.
c) Put 100 for Maximum duration.
d) Put 5000 for Maximum file size.
e) Give a File Name Prefix.
f) Click on Save Settings.
Step 22: Under Event, click on Add.
Step 23: Under Event,
a) Give a Event name.
b) Tick the box for Enable this event.
c) Select Video motion detection under Trigger.
d) Select Always under Event Schedule
Step 24:
a) Select the server name you had created.
b) Select the attached media name that you had created
c) Click on Save Setting.
Thank you